This study tested the accuracy of the Restraint Control Module (RCM) Event Data Recorder (EDR) on a 2010 Ford Flex during both straight line steady state and maximum ABS braking.
Six runs were made starting from 48 kph (30 mph), six runs starting from 80 kph (50 mph), and six runs starting from 113 kph (70 mph). Nondeployment events were artificially induced after a period of steady state driving followed by maximum braking for the last 2.5 seconds prior to creating the event, which was intended to simulate braking just prior to a crash. Following each run, data were collected from the RCM EDR using the Bosch Crash Data Retrieval system. A Racelogic VBOX SL3 20 Hz differential GPS speed data recorder also served as a data acquisition system for vehicle CAN bus speed, accelerator position, RPM, and brake tape switch data. Graphs of RCM speed/brake/accel pedal data compared with VBOX speed and other data over time are presented. The differences between RCM and VBOX speed were plotted and fitted to linear model, using the method of least squares. Under steady state conditions, the RCM EDR average under-reporting error was 1.4 percent at 113 kph (70 mph), and the 99-percent confidence interval was within 2.5 percent at 113 kph (70 mph). During hard braking, the EDR under-reports an average of 3 kph (1.9 mph) compared to VBOX GPS, with a worst case of 6.8 kph (4.2 mph) at approximately 60 kph (37.2 mph), due to the expected wheel slip during hard braking. (publisher abstract modified)
Downloads
Similar Publications
- I studied ShotSpotter in Chicago and Kansas City – Here’s What People in Detroit and the More Than 167 Other Cities and Towns Using This Technology Should Know
- Nuclear DNA from Rootless Hair for Forensic Purposes
- ChatGPTing Securely: Using Machine Learning to Automate Writing Rape Reports, Closed Source Large Language Models